Advertisement
4
—
Program settings
—
01 Faceplate buttons
R G M 4 0 M E T E R Q U I C K S TA R T G U I D E
Program settings using the faceplate buttons:
(MENU, ENTER, DOWN ARROW, RIGHT ARROW)
See figure 01 for the location of the faceplate
buttons. See the user manual for display details.
Access configuration mode:
1. Push the MENU button — you will see the
display below; rSt will be blinking.
2. Press the DOWN ARROW once. CFG
(configuration) moves to the top of
the display.
A
B
C
3. Press the ENTER button. You will see the
configuration menu, shown below.
A
B
C
4. Press the DOWN ARROW and then press the
ENTER button. You will see the CT numerator
setting screen (Ct-n). The current CT
numerator is shown in the second line. To
change the setting, press the DOWN ARROW
until the value you want is displayed. Then
press the RIGHT ARROW to move to the next
digit. Repeat until the setting is done.
A
B
C
5. Press the ENTER button to go to the CT
denominator screen (CT-d). This setting is
display only — it can't be changed.
6. Press the ENTER button to go to the CT
scaling setting screen (CT-S). The current
scaling is shown in the second line. Press the
DOWN ARROW to choose another value. You
can choose 1, 10 or 100.
A
B
C
7. Press the ENTER button to go to the PT
numerator setting screen (Pt-n).The current
PT numerator is shown in the second line. To
change the setting, press the DOWN ARROW
until the value you want is displayed. Then
press the RIGHT ARROW to move to the next
digit. Repeat until the setting is done.
A
B
C
8. Press the ENTER button to go to the PT-
denominator screen (Pt-d). The current PT
denominator is shown in the second line. To
change the setting, press the DOWN ARROW
until the value you want is displayed. Then
press the RIGHT ARROW to move to the next
digit. Repeat until the setting is done.
A
B
C
9. Press the ENTER button to go to the PT
scaling setting screen (PT-S). The current
scaling is shown in the second line. Press the
DOWN ARROW to choose another value. You
can choose 1, 10, 100 or 1000.
Note: See example CT and PT settings on page 5
of this quick start guide.
A
B
C
Advertisement
