Table of Contents
Advertisement
Sensyflow FMT200-ECO2 THERMAL MASS FLOWMETER | OI/FMT200-ECO2-EN REV. H
Parameter descriptions
NOTICE
Data loss
Data loss due to the shut-off of power supply during the
initialization phase (status LED blinks red) of the device.
•
Do not switch off the power supply until the device is
ready for operation(status LED is continuous green).
Saving the parameterization
If any parameterization has been changed in the
parameterization program and transferred to the device through
the 'Accept' button, a save / initialization phase of the device
follows and the status LED blinks red.
•
The supply voltage must not be switched off until the status
LED is continuous green once more.
The modified parameters will not be saved properly if this rule is
not obeyed.
After the repeated power-up of the device, a data inconsistency
will be detected during the initialization phase, the status LED
will switch to continuous red and the device will no longer
function correctly.
Reestablish the parameterization
Once the status LED is continuous red, communication with the
parameterization software can be resumed.
1. The parameterization data must be resaved by selecting the
'Accept' button.
•
Wait until the symbol indicating that a program is running
disappears and the status indication for the 'initialization
phase' is terminated.
•
The status LED is still continuous red at this stage.
2. Perform a hardware reset by powering down and powering
up the power supply.
•
After the initialization phase, the status LED is
continuous green and the device is ready for operation.
Note
If operation readiness cannot be reestablished, contact ABB
Service.
Menu bar
Menu / parameter
Description
Configuration
Factory settings
Shows the parameters set at the factory
Savings
Saves the current parameter set to a data storage
medium.
Load
Loads a saved parameter set from a data storage
medium.
Delete
Deletes a saved parameter set from a data storage
medium.
Print
Prints the current parameter set to the configured
standard printer.
Select Language
Select the program language:
German, English, French
Select unit
Select the flow unit from a unit list.
Insert / delete unit
Create / delete a new unit.
Refer to Add user-defined unit on page 16.
Exit
Exits the parameterization program.
Connection
Connection
Select the serial interface for connection with the
sensor.
Data backup
Data backup
Save the changed data to the device
15
Advertisement
Table of Contents
