Mechanical Installation; Equipment Pre-Installation Checklist; Unpacking; Items Supplied - Danfoss VLT HVAC Drive FC 102 Operating Instructions Manual

Mechanical Installation

3 Mechanical Installation

3.1 Equipment Pre-Installation Checklist

3 3
•
Before unpacking the frequency converter,
examine the packaging for signs of damage. If
the unit is damaged, refuse delivery and
immediately contact the shipping company to
claim the damage.
•
Before unpacking the frequency converter, locate
it as close as possible to the final installation site
•
Compare the model number on the nameplate to
what was ordered to verify the proper equipment
•
Ensure each of the following are rated for the
same voltage:
-
-
-
•
Ensure the output current rating is equal to or
greater than the motor full load current for peak
motor performance.
-
-

3.2 Unpacking

3.2.1 Items Supplied

Items supplied may vary according to product configu-
ration.
•
Make sure the items supplied and the
information on the nameplate correspond to the
order confirmation.
•
Check the packaging and the frequency converter
visually for damage caused by inappropriate
handling during shipment. File any claim for
damage with the carrier. Retain damaged parts
for clarification.
NOTICE
Do not remove the nameplate from the frequency
converter (loss of warranty).
16
Operating Instructions
Mains (power)
Frequency converter
Motor
Motor size and frequency converter
power must match for proper overload
protection.
If frequency converter rating is less than
that of the motor, full motor output is
impossible.
Danfoss A/S © Rev. 2014-07-29 All rights reserved.
VLT
R
Automation Drive
www.danfoss.com
1
T/C: FC-302PK37T2E20H1BGXXXXSXXXXA6BKC4XXXD0
2
P/N: 131X3537 S/N: 010122G430
4
0.37kW/ 0.50HP
5
IN: 3x200-240V 50/60Hz 2.2A
6
OUT: 3x0-Vin 0-1000Hz 2.4A
7
CHASSIS/ IP20 Tamb.50 C/122 F o
* 1 3 1 X 3 5 3 7 0 1 0 1 2 2 G 4 3 0 *
Listed 76X1 E134261 Ind. Contr. Eq.
CAUTION:
See manual for special condition/mains fuse
10
voir manual de conditions speclales/fusibles
WARNING:
Stored charge, wait 4 min.
`
Charge residuelle, attendez 4 min.
1 Type code
2 Order number
3 Serial number
4 Power rating
Input voltage, frequency and current (at low/high
5
voltages)
Output voltage, frequency and current (at low/high
6
voltages)
7 Enclosure type and IP rating
8 Maximum ambient temperature
9 Certifications
10 Discharge time (Warning)
Illustration 3.1 Product Nameplate (Example)

3.3 Installation Environment

3.3.1 Planning the Installation Site

Select the best possible operation site by considering the
following (see details on the following pages, and in the
Design Guide):
•
Ambient operating temperature
•
Installation method
•
Cooling
•
Position of the unit
•
Cable routing
•
Voltage and current supply from power source
•
Current rating within range
•
Fuse ratings if not using built-in fuses
3
9
8
o
MADE IN DENMARK
`
MG16I202