Edit Reader; Delete Reader; Calibrate Sensor; Add User - CAMDEN CV-940-20 Series Installation Instructions Manual

9.2 Edit Reader

• Right-click on the reader and select Properties
(Fig. 9.2 a)
• Edit reader properties and click Save button
(Fig. 9.2 b)
• Right click on the reader and select Upload
configuration (Fig. 9.2 b)
• Check at event table if configuration was successful
(Fig. 9.2 c)

9.3 Delete Reader

• Right-click on the reader and select Delete reader

9.4 Calibrate Sensor

• Right-click on the reader and select Calibrate
• See the events panel to check the calibration flow
It is recommended to do sensor calibration once
after reader is mounted. Clean the fingerprint sensor
before calibration.

9.5 Add User

• At user table, click on the last empty user field and
enter user name
• Click on ID (User code) field and enter ID number.
This number will be sent by the reader to the access
controller when user finger is recognized by the reader
Fig. 9.2 a
• Click on PIN code field and enter the PIN. PIN code is
used at readers with keypad. When PIN code is typed
at reader, User ID will be sent to the access controller
Page 16 of 21
CV-940-20 Series
Fig. 9.2 b
Fig. 9.2 c