Table of Contents
Advertisement
8.8 Change PIN Code Length
• Go to Settings/ System parameters. (8.24)
• Select the desired length and click "Save&Exit". (8.25)
• All the readers in the network will automatically receive
the change
Note: It is recommended to do this setting immediately
after installing the software, as this parameter will set the
available number of PIN Code digits in the user form.
8.24
8.9 Sensor Calibration
• Right click on the biometric reader and select
"Calibrate" and wait for confirmation message
Note: It is recommended to do a calibration while
commissioning the reader and in cases when there
are problems with reading the fingers
8.10 Send Configuration
• Right-click on the reader and select the Send
configuration menu
• See the events panel to check the configuration flow
Note: The biometric reader gets its settings automatically.
This function is used if the reader was off line while
making the changes.
Example:If the PIN code length is set to 6 digits, then in
the Users Window, the PIN Code will require 6 digits
entry. (8.26)
8.25
Page 13 of 21
CV-940-20 Series
8.26
8.27
8.28
Advertisement
Table of Contents
