Enrolling Fingerprints From A Reader - CAMDEN CV-940-20 Series Installation Instructions Manual

8.2 Enrolling Fingerprints From a Reader

1. Open the Users Window and create a new user. Click
on "New User", put a name, ID(card number) and
Access Code. 8.7)
2. Go to the "Biometric" Tab
3. Select the reader(with left click) from which the
enrollment will be done. (8.8)
4. Right click on the fingertip and select enroll. (8.9)
5. In the next 25 sec. present the finger on the selected
reader and the finger tip will turn red, with the
percentage of successful enrollment shown next to
the fingertip. (8.10) In these 25 sec. the reader will
continuously blink in orange.
6. Repeat point 4&5 for each finger that should
be enrolled.
8.7
8.10
8.12
7. Click on "Save New" and the fingerprint will be sent
automatically to all Biometric Readers where that user
has access, i.e. to all the readers according to the Access
Level assign to that user.
Example: If the user has "Unlimited" Access level then
the fingerprints will be sent to all readers, if the user has
Access level only for Reader1 and Reader 3 then the
fingerprints will be sent only to those two readers.
Note: To check if all the fingerprints are sent to the
reader, right click on the reader and select "Memory
Status". (8.11) In the event window a line will appear
indicating the number of fingerprints stored in the
reader. (8.12)
If more fingerprints are added for one user, all fingerprints
will send the same Wiegand Code to the controller, the
one written in the field User ID(card Number).
8.8
8.11
Page 9 of 21
CV-940-20 Series
8.9