Kohler Command Pro CV173 Service Manual page 59

Install Carburetor and Gaskets
A
B
C
D
A Carburetor Stud
C Carburetor Spacer
E Carburetor
G Throttle Linkage
Install Carburetor Gaskets
1. Place new spacer gasket then carburetor spacer on
carburetor studs.
2. For engines that have a speed control bracket
equipped with a stop switch, slide ignition kill lead
through slot in carburetor heat shield gasket and
install gasket on carburetor studs.
Install Carburetor and Linkages
1. Move throttle control clockwise to full choke position,
and slide carburetor onto studs while connecting
choke linkage.
2. Turn throttle lever clockwise until it stops. Gently
push rod and spring linkages up to connect them to
throttle lever.
3. If equipped, connect ignition kill lead terminal to stop
switch on speed control assembly.
14 690 12 Rev. --
H
G
E
F
B Spacer Gasket
Carburetor Heat
D
Shield Gasket
F Choke Linkage
H Ignition Kill Lead Slot
KohlerEngines.com
Reconnect Fuel Line
B
A
A B
D
A Hose Clamp
Fuel Filter (if
C
equipped)
1. Slide fuel line tight up against carburetor, and secure
connection with a hose clamp.
2. Ensure that in-nipple fuel fi lter is in place in fuel tank
outlet.
3. Connect fuel line to fuel tank and slide hose clamp to
secure.
Reassembly
B
C
A
B
B Fuel Line
D In-nipple Fuel Filter
59