Air Cleaner/Intake; Air Cleaner; Breather Tube; Air Cooling - Kohler Command Pro CV173 Service Manual

AIR CLEANER

These systems are CARB/EPA certifi ed and components
should not be altered or modifi ed in any way.
Air Cleaner Components
F
E
D
C
A Air Cleaner Cover
C Paper Element
E Latch
NOTE: Operating engine with loose or damaged air
cleaner components could cause premature
wear and failure. Replace all bent or damaged
components.
NOTE: Paper element cannot be blown out with
compressed air.
Move bails on air cleaner cover down; remove latches
from under tabs on base; remove cover.
Precleaner (if equipped)
1. Remove precleaner from paper element.
2. Replace or wash precleaner in warm water with
detergent. Rinse and allow to air dry.
3. Lightly oil precleaner with new engine oil; squeeze
out excess oil.
4. Reinstall precleaner over paper element.
Paper Element
1. Separate precleaner from element; service
precleaner and replace paper element.
2. Install new paper element on base; install precleaner
over paper element.
Reinstall air cleaner cover and place latches under tabs
on base; lift up bails to secure cover.
14 690 12 Rev. --
A
B
B Precleaner
D Base
F Bail
KohlerEngines.com

BREATHER TUBE

Make sure both ends of breather tube are properly
connected.

AIR COOLING

Hot Parts can cause severe burns.
Do not touch engine while operating or just
after stopping.
Never operate engine with heat shields or guards
removed.
Proper cooling is essential. To prevent over heating,
clean screens, cooling fi ns, and other external surfaces
of engine. Avoid spraying water at wiring harness or any
electrical components. Refer to Maintenance Schedule.

Air Cleaner/Intake

WARNING
27