Kohler Command Pro CV173 Service Manual page 15

TORQUE SPECIFICATIONS
Finger Guard (as equipped)
Rear Guard Fastener
Side Guard Fastener (Muffl er Side, Carburetor Side)
Flywheel
Retaining Nut
Fuel Tank (if equipped)
Lower Tank Bracket to Crankcase Screw
Stud
Governor
Lever Fastener
Gear Fastener
Ignition
Spark Plug
Module Fasteners (Stud or Screw)
Muffl er
Exhaust Stud
Exhaust Nut
Barrel Baffl e (CV200, CV224) Screw to Cylinder Head
Oil Pan (torque sequence on page 14)
Fastener
Clean Oil Change Screw
Oil Drain Plug
7
Oil Filter Nipple
Oil Pump Screen Cover Fastener
Retractable Starter
Fastener
Rocker Arm
Stud
Pivot Jam Nut
Speed Control
Bracket Assembly Fastener
Valve Cover (torque sequence on page 14)
Fastener
Values are in Metric units. Values in parentheses are English equivalents.
3
Lubricate threads with engine oil prior to assembly.
6
7 Apply thread sealant around three full threads before assembly. No excess sealant allowed on inside or outside of
joint. Threads with preapplied sealant do not require use of additional sealant. Approved sealants include Perma-Loc
LH 150, Perma-Loc MM 115, Perma-Loc HH 120, Perma-Loc HL 126.
14 690 12 Rev. --
3,6
KohlerEngines.com
CV173 CV200
10 N·m (89 in. lb.)
9.5 N·m (84 in. lb.)
51.5 N·m (38 ft. lb.)
8 N·m (71 in. lb.)
10 N·m (89 in. lb.)
9.5 N·m (84 in. lb.)
9.5 N·m (84 in. lb.)
27 N·m (20 ft. lb.)
10 N·m (89 in. lb.)
5.0 N·m (44 in. lb.)
9.5 N·m (84 in. lb.)
8 N·m (71 in. lb.)
14.7 N·m (130 in. lb.)
14.7 N·m (130 in. lb.)
13.6 N·m (120 in. lb.)
28.5 N·m (252 in. lb.)
9.5 N·m (84 in. lb.)
8 N·m (71 in. lb.)
13.6 N·m (120 in. lb.)
9.5 N·m (84 in. lb.)
8 N·m (71 in. lb.)
8 N·m (71 in. lb.)
Specifi cations
CV224
15