Table of Contents
Advertisement
Before You Begin
Prerequisites
Caution
2-2 Getting Started
Before beginning the tutorial presented in this chapter, you must have
completed the following tasks:
1. Connected the emulator to your computer. The HP 64700
Series Installation/Service manual shows you how to do this.
2. Installed the Softkey Interface software on your computer.
Refer to the HP 64700 Series Installation/Service manual for
instructions on installing software.
3. In addition, you should read and understand the concepts of
emulation presented in the Concepts of Emulation and
Analysis manual. The Installation/Service manual also covers
HP 64700 system architecture. A brief understanding of these
concepts may help avoid questions later.
4. Connected the emulator to the emulation probe as shown in
Figure 2-1.
Turn off power of the emulator before inserting the cables to the
emulation pod to avoid circuit damage.
Advertisement
Table of Contents
