Notification Connector - Prestige APSRS Installation And Reference Manual

Detailed Descriptions: Wire Harness Colors and Functions
Power Connector (8-pin High-Current Connector) (Cont)
These wires are listed in order of their placement in the harness connector.
7. PURPLE – Accessory Output (+)
At its default setting, the PURPLE wire supplies 12-Volt (+) to the vehicle's accessory wire to power vehicle accessories
during remote start.
Verification: The accessory wire registers 12-Volt (+) when the vehicle is running or in accessory mode, but not during
engine crank or if the vehicle is off.
Note: This wire can be programmed to perform a different function by changing its options.
on page 12.
8. BLUE – Ignition 1 Input / Output (+)
The BLUE wire supplies 12-Volt (+) to the vehicle's primary ignition wire during remote start. This wire is also used to
sense vehicle ignition for the Programming Functions
Verification: The primary ignition wire registers 12-Volt (+) when the vehicle is in ignition mode AND during engine crank.
Notification Connector (4-pin connector)
These wires are listed in order of their placement in the harness connector.
1. WHITE – Parking Light Relay Output (Internal Relay Pin 30)
At its default setting, the WHITE wire supplies 12-Volt (+) or Ground (-) to the vehicle's park light wire based on the
connection of the relay input (WHITE/RED wire).
Verification: The vehicle parking light wire registers 12-Volt (+) or Ground (-) when the park lights are turned on.
Note: This wire can be programmed to perform the Trunk Release Output function by changing its options.
Bank 2, Feature 14 on page 9.
2. WHITE/RED – Parking Light Relay Input (Internal Relay Pin 87)
The WHITE/RED connects to vehicle 12-Volt (+) or Ground (-) to supply the relay output (WHITE wire).
Verification for default setting:
• If the vehicle parking light wire registers 12-Volt (+) when the park lights are on, connect the WHITE/RED wire to a
constant 12-Volt (+) vehicle wire.
• If the vehicle parking light wire registers Ground (-) when the park lights are on, connect the WHITE/RED wire to a
reliable vehicle ground source.
Note: This wire can be programmed to perform the Trunk Release Output function by changing its options.
Bank 2, Feature 14 on page 9.
3. YELLOW/BLACK – Ignition Output to Alarm (+)
The YELLOW/BLACK wire supplies 12-Volt (+) ignition output when the vehicle's ignition is set to ON, but not during the
remote start runtime. This output will be used when an external alarm system is added to the vehicle.
4. BLACK – Ground Input (-)
The BLACK wire connects to a reliable vehicle ground (-) source to power the system.
Verification: The vehicle ground (-) source wire registers ground (-) at all times.
Note: Before making this connection, remove all module fuses until the system is completely connected.
APSRS_RevC_9/17
See page 28 for the full system diagram.
1 3
2 4
See page 28 for the full system diagram.
Refer to Bank 3, Feature 9
Refer to
Refer to
3