Input / Output Connector - Prestige APSRS Installation And Reference Manual

Detailed Descriptions: Wire Harness Colors and Functions
Input / Output Connector (22-pin connector)
These wires are listed in order of their placement in the harness connector.
1. ORANGE – Starter Kill Output (-)
The ORANGE wire supplies Ground (-) when the alarm is armed and when the remote start is ON.
2. LIGHT GREEN – Trunk / Hatch Input (-)
The LIGHT GREEN wire connects a device or switch that, when triggered, supplies a Ground (-) output. If the system is
armed, this input will trigger the alarm.
3. GRAY/BLACK – Hood Input (-)
The GRAY/BLACK wire connects to the vehicle's hood switch, or an installed switch that registers Ground (-) when
triggered.
Verification: The vehicle hood switch wire registers Ground (-) when the hood is opened.
4. GREEN/ORANGE – Tach Input
The GREEN/ORANGE wire connects to the vehicle's tach wire at the negative side of the ignition coil or fuel injector to
control engine crank during remote start.
Verification:
• Using a voltmeter set to AC volts, connect the voltmeter's positive lead to a constant vehicle
12-Volts (+) source and the negative lead to the wire to be tested.
• Start the engine and have a partner slowly press the gas pedal while the transmission is in Park. If the voltage
increases as the RPM increases, this is the proper tach wire.
5. LIGHT BLUE – Remote Start Status Output (-) (NOC 1)
The LIGHT BLUE wire supplies Ground (-) as soon as the remote starter is activated and remains active until 4 seconds
after remote start run time has ended. This wire is most commonly used to activate data integration modules.
Note: This wire is programmable.
6. PURPLE/BROWN – Door Trigger Input (-/+)
The PURPLE/BROWN wire connects to the vehicle's door trigger wire. This wire will detect 12-Volt (+) or Ground (-) input.
Verification: The vehicle door trigger wire registers 12-Volt (+) or Ground (-) when a door is opened and opposite when
closed.
Note: Programming is required if the door trigger wire registers 12-Volt (+).
7. GREEN/WHITE – Dome Light Output (-) (NOC 2)
The GREEN/WHITE wire supplies Ground (-) when Unlock is activated from the Remote Control. This output will
automatically turn off after 30 seconds.
Note: This wire is programmable.
8. GREEN/YELLOW – Diesel Glow Plug Input (+)
The GREEN/YELLOW wire connect to the vehicle's Diesel Glow Plug detection wire.
Verification: This wire will register as 12-Volt (+) while the Diesel Wait to Start Light is illuminated.
9. BLACK/YELLOW – Pulse During Crank Output (-) (NOC 3)
At its default setting, the BLACK/YELLOW wire supplies a Ground (-) pulse when the engine cranks during remote start.
Note: This wire is programmable.
4
1 3 5 7 9
2 4 6 8 10
Refer to NOC Programming on page 16.
Refer to NOC Programming on page 16.
Refer to NOC Programming on page 16
See page 28 for the full system diagram.
11 13 15 17 19 21
12 14 16 18 20 22
Refer to Feature Programming on page 9.
APSRS_RevC_9/19