Quick Reference - Prestige APSRS Installation And Reference Manual

Quick Reference: System Programming
Programming Mode Entry and Exit Procedure
Once the system is installed and powered up, you will use the vehicle ignition, override button and a programmed
remote control to set all system options. Feature options are divided into categories, or Banks, as described throughout
this section. Ensure that at least one remote control is programmed to the system. If not, or if you need to program
more remote controls, use the diagram steps to access Bank 1.
The siren and LED will indicate your status and selections. Follow the diagram below to enter and maneuver through the
programming procedure.
3X
Ignition On Press and Release
Override Button
Ignition O
1. Turn the ignition ON.
2. Press and release the valet/override button 3x.
3. The system will beep (1) one time, indicating you have accessed Bank 1.
4. Each cycle of the Ignition, OFF/ON, will advance to the next bank (up to Bank 3) then restart at Bank 2. (Note: To re-
access Bank 1 for transmitter programming, you will need to exit and re-enter programming mode.)
5. The system will beep a number of times to indicate the Bank number:
• 1 beeps: Bank 1 - Programming Remote Controls
• 2 beeps: Bank 2 - Keyless Control Options
Bank 3 - Remote Start Control Options
• 3 beeps:
6. Once you have accessed the desired bank, press the valet/override button to advance though the features. The LED
will flash a number of times to indicate the feature, based on the charts that follow this section. The system will chip
a number of times to indicate the Option programmed.
7. Once you have accessed the desired feature, press the LOCK button on the remote control to advance though the
feature's setting options. The system will beep a number of times to indicate the Option setting, based on the charts
that follow this section.
8. Once you have made the desired setting, you can press the valet/override button to advance through the
features within the bank, or cycle the Ignition key OFF/ON to advance to the next bank.
9. Once you have completed programming, you MUST turn the ignition key to OFF to exit the programming
mode. Programming will automatically exit after 60sec of inactivity.
APSRS_RevC_9/17
1X
1 Chirp = Bank 1 Cycle Key to Advance
(Program Remotes) Banks (2,3)
... or Exit
Programming
Note: Programming will time out after 60sec with no activity or Ignition Off for 5sec.
2 = Bank 2
3 = Bank 3
Chirps Indicate Press Override Button to
Bank Number Advance Within Bank
Repeat Steps to Program
Another Feature Bank...
LED Indicates Press to Change
Feature Selection Feature Option
Repeat Steps to Program
Another Feature ...
Chirps Indicate
Option Number
21