Setup Options; Remote Programming - Prestige APSRS Installation And Reference Manual

Detailed Descriptions: Setup Options
Bank 1: Add / Remove Remote Controls
Remote programming is located in Feature Bank 1. This system will Auto Program basic functions of the remote with one
(1) button press. Basic functions are channels 1-3, Lock, Unlock, and Trunk / Start.
To Auto Program a remote control:
1. Turn the ignition key to ON.
2. Press and release the valet/override button three (3) times.
3. The system will beep one (1) time, indicating you have accessed Bank 1, Remote Programming.
4. Press the Lock button of each remote control you wish to program. (Channels 1-3 of the remote control will be
programmed.) The system will beep one (1) time when each remote control is added.
5. Turn the ignition key to OFF to exit programming mode, or cycle the ignition key OFF/ON to advance to the next
Feature Bank.
To delete a remote control:
This system will store a maximum of four (4) remote controls in the memory. Additional programmed remote controls
will delete the oldest-programmed remote control.
Deleting All Remotes:
1. Perform steps 1-3 above.
2. Press and hold the Valet/Override button for five (5) seconds.
3. The system will sound one (1) long beep. This indicates all remotes have been deleted from memory.
Notes:
The system will store in the memory a maximum of four (4) remote controls. Additional programmed
•
remote controls will delete the oldest-programmed remote control.
• The system will accept a maximum of two (2) 2-Way remote controls.
• During normal operation, the Programmed Transmitter Notification (PTN) function indicates how many
remote controls are programmed by flashing the LED a certain number of times when the vehicle ignition is
turned on.
AUX Output Controls.
AUX Output Controls are not configured during the Auto Programming sequence. This allows for customization by the
installer or user. To program AUX Output Control:
1. Repeat steps 1-3 above.
2. Press the valet button to advance to the AUX Channel to be programmed. The system will beep to indicate the
channel number.
3. Press the desired button or button combination selected to control the AUX output. The system will beep 1x to
indicated the channel is programmed.
4. Repeat steps 2-3 until all desired AUX outputs are programmed or turn the ignition key to OFF to exit programming.
8
Feature Bank 1
1 Auto Program/Lock Press Lock button on remote
2 Unlock Press Unlock button on remote
3 Trunk/Start Press Trunk/Start button on remote
Press button/buttons to control AUX Ch. 4
4 Ch. 4 AUX
5 Ch. 5 AUX Press button/buttons to control AUX Ch. 5
6 Ch. 6 AUX Press button/buttons to control AUX Ch. 6
7 Ch. 7 AUX Press button/buttons to control AUX Ch. 7
Description
APSRS_RevC_9/19