Wire Harness Colors And Functions; Power Connector - Prestige APSRS Installation And Reference Manual

Detailed Descriptions: Wire Harness Colors and Functions
Power Connector (8-pin High-Current Connector)
These wires are listed in order of their placement in the harness connector.
1. RED/BLACK – Ignition 3, Flex Relay Input (Internal Relay Pin 87)
The RED/BLACK wire is used to supply the Pin 2 - PINK Flex Relay Output. This wire can be connected to 12-Volt (+) or
Ground (-). Please check vehicle requirements for correct polarity.
Note: Before making this connection, remove all module fuses until the system is completely connected.
2. PINK – Ignition 3 Flex Relay Output (Internal Relay Pin 30)
At its default setting, the PINK wire supplies 12-Volt (+) or Ground (-) to the vehicle's secondary ignition wire during
remote start. The polarity of this output is provided by the Pin 1, RED/BLACK Input.
Verification: If present, the secondary ignition wire registers 12-Volt (+) or Ground (-) when the vehicle is in ignition mode
AND during engine crank.
Note: This wire can be programmed to perform a different function by changing its options.
on page 12.
3. YELLOW – Starter Output for Remote Start (+)
The YELLOW wire supplies 12-Volt (+) to the vehicle's starter wire when remote start is enabled, and turns off once the
vehicle is started.
Verification: This starter wire registers 12-Volt (+) during engine crank.
Note: If installing a starter kill relay in addition to remote start, connect the YELLOW wire to the MOTOR SIDE of the cut
starter wire. Refer to Start Kill diagram on page 29.
4. GREEN – Ignition 2 Output (+)
At its default setting, the GREEN wire supplies 12-Volt (+) to the vehicle's secondary ignition wire during remote start.
Verification: If present, the secondary ignition wire registers 12-Volt (+) when the vehicle is in ignition mode AND during
engine crank.
Note: This wire can be programmed to perform a different function by changing its options.
on page 12.
5. RED – 12-Volt Input (+)
The RED wire connects to the vehicle's primary 12-Volt (+) wire to power the system.
Verification: The power wire registers 12-Volt (+) at all times.
Note: Before making this connection, remove all module fuses until the system is completely connected.
6. RED/WHITE – 12-Volt Input (+)
The RED/WHITE wire connects to the vehicle's secondary 12-Volt (+) wire to power the remote start function.
Verification: The power wire registers 12-Volt (+) at all times.
Note: Before making this connection, remove all module fuses until the system is completely connected.
2
1 3 5 7
2 4 6 8
See page 28 for the full system diagram.
Refer to Bank 3, Feature 8
Refer to Bank 3, Feature 7
APSRS_RevC_9/19