Table of Contents Using Your Remote Control ....................3 Arming the Security System ..................3 Disarming the Security System ..................3 Two Stage Door Unlock (optional) ................3 Activating Trunk Release (optional) ................3 Activating AUX Output (optional) ................. 3 Using the Personal Protection Alarm ................
(if the option is installed). To stop the alarm, press and hold the button on the remote control again for three (3) seconds. The system will automatically stop after thirty (30) seconds. 2020 Voxx Electronics Corporation. All rights reserved.
Bypassing The Shock Sensor The included security shock sensor has two stages of detection, Warn-Away and Full Trigger. To arm the system and shock sensor press the button. The system will chirp and the lights will flash one (1) time. To Arm the system and bypass the Warn-Away detection stage press the button two (2) times within five (5) seconds.
Within ten (10) seconds, press and release the Brake pedal three (3) times. The alarm system will stop sounding and enter the (by-passed) mode. You can now start and operate the vehicle normally. This feature must be programmed ON by an authorized dealer. 2020 Voxx Electronics Corporation. All rights reserved.
Page 6
Custom Code Valet Override (Optional) Unlike the default Valet Override, Custom Code Override is a user personalized code that offers a higher level of security. If the user chooses to use Custom Code Override, Feature Bank 2 ; Feature 9 must be programmed for “Custom Code”.
The engine is over-revved (tach checking only). • Remote Start Service Mode is active. Refer to the Valet Mode section of this manual on page 11. • Remote Start Ready Mode is not set. Manual transmission vehicles only. 2020 Voxx Electronics Corporation. All rights reserved.
Remote Start Ready Mode must be enabled if your vehicle is equipped with a manual transmission. Remote Start Ready Mode - Manual Transmission Vehicles Only To activate the remote start function, the system must first be in Remote Start Ready Mode. Follow the steps below to enter remote start ready mode. •...
The unit enters Quick Stop Mode and will remain running until remote start time-out and then shuts down. (Remote Start Ready Mode is now active) Note: Do not leave children or animals unattended in the vehicle when using the quick-stop feature. 2020 Voxx Electronics Corporation. All rights reserved.
Operating the 2 / 4 Hour Start Up Timer Mode The system has the ability to start the vehicle every two (2) or four (4) hours for a forty-eight (48) hour period. This feature is especially useful in cold climates where the only means to keep the engine and engine fluids warm is to periodically start the engine.
Release the valet override button. The LED will begin to flash two (2) short flashes followed by one (1) long flash to indicate Remote Start Service Mode is active. Repeat steps 1-3 above to disengage Service Mode. 2020 Voxx Electronics Corporation. All rights reserved.
Page 12
Status LED, Light Flashes, and Horn Indications Status LED Flash Indications LED Flashes Function Disarmed Slow Flash Armed Fast Flash Passive Arming Countdown ON (Solid) Valet Mode 1 Flash / Disarmed Zone 1 Trigger, Shock Sensor 2 Flashes / Disarmed Zone 2 Trigger, Trunk / Hood 3 Flashes / Disarmed Zone 3 Trigger, Door...
Using a coin, disassemble the halves of the remote control. Remove the old battery, observing the +/- symbols on the batteries and replace with a new battery. Reassemble the halves of the remote control. Test operation of the remote control. 2020 Voxx Electronics Corporation. All rights reserved.
Page 15
LIMITED LIFETIME WARRANTY Voxx Electronics Corporation (the Company) warrants to the original purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within the Lifetime from the date of original purchase in the original vehicle, such defect(s) will be repaired or replaced with new or reconditioned product, (at the Company’s option) without...
Page 16
Voxx Electronics Corporation. Customer Service 1-800-225-6074 www.VoxxElectronics.com FCC COMPLIANCE This device complies with Part 15 of the FCC rules and with RSS- 210 of Industry Canada. Operation is subject to the following two conditions: This device may not cause harmful interference, and This device must accept any interference received, including any interference that may cause undesired operation.