Mower Spindle Assembly (2010 & Later Model G3, 3000/5000/6000 Series Units) - Toro Z Master G3 3000 Series Service Manual

MOWER DECKS
Note: There is a snap ring located in the spindle
housing (Fig. 444). If replacing the bearings
and seals only, there is no need to remove the
snap ring, unless it shows damage.
6
6-20
Fig. 444 DSCN-0106a
Mower Spindle Assembly (2010 &
Later Model G3, 3000/5000/6000
Series Units)
1. Install the bottom bearing. Press up against the snap
ring (Fig. 445).
2. Apply a film of grease around the lip of the seal and
install the lip of the seal face inward (Fig. 446).
Toro Z Master G3 3000/5000/6000 Series Service Manual
Fig. 445 DSCN-0118a
Fig. 446 DSCN-0119a