User Parameters; Chapter 8 - Summary Of Parameter Settings - Watt Drive V2500 Series Manual

CHAPTER 8 SUMMARY OF PARAMETER SETTINGS
!: The parameter can be set during operation.
*: Twice the value or higher value for 400/460V class
Group 0: User Parameters
Para-
Explanation
meter
00-00 Identity Code of AC Drive
00-01 Rated Current Display
00-02 Parameter Reset
Start-up Display Page
00-03
Selection
Content of Multi Function
00-04
Display
00-05 User-Defined Coefficient K ! 0.01 to 160.00
00-06 Software Version
00-07 Password Decode
00-08 Password Setting
00-09 Control Methods
00-10 Reserved – Do Not Change!
Settings
Read-only
Read-only
08: Keypad lock
09: Reset parameter to factory setting
(50Hz, 230/400Vac)
10: Reset parameter to factory setting
(60Hz, 230/460Vac)
00: F (setting frequency)
01: H (actual frequency)
02: U (user-defined unit)
!
03: Multi Function Display
04: FWD/REV command
00: Display output current (A)
01: Display counter value (C)
02: Display process operation (PLC
time) (1. tt)
03: Display DC-BUS voltage (U)
04: Display output voltage (E)
05: Output power factor angle (n.)
06: Display output power (kW)
07: Display actual motor speed (HU)
08: Display the estimative value of the
ration of torque (t)
09: Display PG numbers/10ms (G)
10: Display analog feedback signal
value (b)
11: Display AVI (U1.) (%)
12: Display ACI (U2.) (%)
13: Display AUI (U3.) (%)
Read-only
1 to 65535
0 to 65535
00: V/F Control
01: V/F + PG Control (also see Pr.10-09
to 10-11)
02: Vector Control
03: Vector + PG Control (also see
Pr.10-09 to 10-11)
8-1
Factory Actual
Setting Setting
##
##.#
0
01
8
00
1.00
#.##
00
00
02