Watt Drive V2500 Series Manual page 34

CHAPTER 5': QUICK START GUIDE
Para-
Explanation
meter
Source of First Operation
02-01
Command
Groupe 3: Output Function Parameters
Groupe 4: Input Function Parameters
04-00 AVI Analog Input Bias
04-01 AVI Bias Polarity
04-02 AVI Input Gain
AVI Negative Bias,
04-03
Reverse Motion Enabled
04-04 Multi-Function Input 1 (DI1)
04-05 Multi-Function Input 2 (DI2)
04-06 Multi-Function Input 3 (DI3)
04-07 Multi-Function Input 4 (DI4)
04-08 Multi-Function Input 5 (DI5)
04-09 Multi-Function Input 6 (DI6)
Settings
00: Determined by digital keypad
01: Master frequency determined by
external terminal, keypad STOP
enabled.
02: Master Frequency determined by
external terminal, keypad STOP
disabled.
!
03: Master Frequency determined by
RS-485 communication interface,
keypad STOP enabled.
04: Master Frequency determined by
RS-485 communication interface,
keypad STOP disabled.
0.00 to 100.00 %
00: Positive bias
01: Negative bias
1 to 200 %
00: no AVI Negative bias command
01: Negative bias, REV motion enabled
02: Negative bias, REV motion disabled
01: Multi-Step Speed Command 1
02: Multi-Step Speed Command 2
03: Multi-Step Speed Command 3
04: Multi-Step Speed Command 4
05: External Reset
06: Accel/Decel Speed Inhibit
07: First or Second Accel/Decel Time
Selection
08: Third or Fourth Accel/Decel Time
Selection
09: External Base Block (N.C.) Input
10: External Base Block (N.O.) Input
11: Increase Master Frequency
12: Decrease Master Frequency
13: Counter Reset
14: Run PLC Program
15: Pause PLC Program
16: Auxiliary Motor No.1 Output Failure
17: Auxiliary Motor No.2 Output Failure
18: Auxiliary Motor No.3 Output Failure
19: Emergency Stop (NO)
20: Emergency Stop (NC)
21: Master Frequency Selection AVI/ACI
22: Master Frequency Selection AVI/AUI
23: Operation Command Selection
(Keypad/Terminal)
24: Disable Auto Accel/Decel Selection
25: Forced Stop (N.C.)
5'-2
Factory Actual
Setting Setting
01
0.00
00
100
00
01
02
03
04
05
07