Preface - Watt Drive V2500 Series Manual

PREFACE

Thank you for choosing WATT DRIVE Antriebstechnik GmbH performance V2500 Series.
V2500 Series are manufactured by adopting high-quality components, material and
incorporating the latest microprocessor technology available.
! Getting Started
This manual will be helpful in the installation, parameter setting, troubleshooting, and
daily maintenance of the AC motor drives. To guarantee safe operation of the
equipment, read the following safety guidelines before connecting power to the AC
drives. Keep this operating manual handy and distribute to all users for reference.
!
DANGER!
This message indicates a situation which may lead to serious injury or
even death if the instruction is not observed.
!
CAUTION!
This message indicates a situation which may lead to minor or moderate
injury, or damage of product.
!
HAZARDOUS HIGH VOLTAGE!
Motor control equipment or electronic controllers are connected to hazardous
line voltages.
When servicing drives and electronic controllers there might exist exposed
components with cases or protrusions at or above line potential.
Extreme care should be taken to protect against shock.
For these reasons, the following safety guidelines should be observed:
Stand on an insulating pad and make it a habit to use only one hand when
checking components. Disconnect power before checking controllers or
performing maintenance. Be sure that equipment is grounded properly. Wear
safety glasses whenever working on an electronic controller or rotating
electrical equipment.
!
DANGER!
This equipment should be installed, adjusted and serviced only by qualified
electrical maintenace personel familiar with the construction and operation of the
equipment and the hazards involved. Failure to observe this precaution could result
in bodily injury.
!
CAUTION!
These instructions should be read and clearly understood before working on V2500
series equipment.
!
DANGER!
The user is responsible that all driven machinery, drive train mechanism not
supplied by WATT Drive Antriebstechnik and process line material are capable of safe
operation at an applied frequency of 150% of the maximum selected frequency range
to the AC motor. Failure to do so can result in destruction of equipment and injury to
personnel should a single point failure occur.
!
DANGER!
HAZARD OF ELECTRICAL SHOCK. DISCONNECT INCOMING POWER BEFORE
WORKING ON THIS CONTROL.
Do not connect or disconnect wires and connectors while power is applied to
the circuit. Maintenance must be performed by qualified technicians.
0-1
0