HBM C16i Series Mounting Instructions page 20

Mounting
18
When EPO3/50t, C16/EPU44A or C16/ZOU44A mount­
ing parts from HBM are used, the integral rotation stop
device, described in chapter 4 "Montage", can be used.
With customized mounting parts, HBM provides drawings
showing the position and mounting of the rotation stop. In
this case, special attention must be paid to the obser­
vance of the tolerances stated for the dowel pin position,
to prevent the load cells from being damaged.
Important
Only when the HBM specifications are followed will the
HBM warranty for the product be valid.
The C16/ZOU44A load introduction parts accessory kit
can be used as an economical alternative for load cells
with nominal loads up to 60 t.
Important
In this case, however, the maximum load for each load
cell must not exceed 40 t.
A1461-2.0 HBM: public
C16i