Table of Contents
Advertisement
4. Select Advanced and press the OK button.
5. Select TCP/IP settings and press the OK button.
• If you specify IPv4 address:
1. Select IPv4.
2. Select Yes on the displayed screen.
3. Select IP address.
4. Select Manual setup.
Selecting Auto setup specifies the IP address automatically.
5. Enter IP address.
6. Select OK.
7. Enter subnet mask.
8. Select OK.
9. Enter default gateway.
10. Select OK.
The IPv4 address has been specified.
• If you specify IPv6 address:
1. Select IPv6.
2. Select Yes on the displayed screen.
3. Select Enable/disable IPv6.
4. Select Enable.
The IPv6 address has been specified.
Important
• If firewall is enabled on the computer, printers on a different subnet may not be detected.
Disable firewall.
521
Advertisement
Table of Contents
