Display Range; How To Select A Range - Furuno GS-100 Operator's Manual

Vector Time
The tip of the vector line on the own ship marker shows the estimated position of your
ship after the selected vector time elapses, using the current course and speed. You
can adjust the length of the vector line to see estimated position at the end of the se-
lected time interval.
1. Press the MENU ESC key to open the menu.
2. Select [Vector Time] then press the ENT key.
3. Select a vector time then press the ENT key. The
longer the time, the longer the vector line.
4. Press the DISP key to close the menu.
6.4

Display Range

6.4.1

How to select a range

The display range is the distance between grid sides on the berthing display. Use the
RNG key to select a range. The range appears below the 3-axis speed display as
shown below. The system is pre-set with five ranges (nm): 0.025, 0.04, 0.05, 0.075
and 0.1. A total of 11 ranges are available and you can select the ranges to use from
the menu, as shown in the next paragraph.
Range
Set with RNG key.
6. BERTHING DISPLAY
Display range
Grid
6-7