One Shot Mode - Racelogic VBOX Mini User Manual

in the LAPTIMING MENU.
Split Widths
When setting a start / finish or split line, the VBOX Mini unit will set the width of the line at a default value of 25 m (12.5
m either side of the point at which the OK button was pressed.) However this can be changed by selecting the Split
Widths function and altering the value using the ▲▼ buttons. This feature is useful if the VBOXMini is being used on a
track where separate sections pass closely by each other, and eliminates the possibility of going through a split line in
the wrong direction.
Clearing your Best Lap time
Press and hold the RESET button for 1.5 s.

One Shot Mode

By default, the VBOXMini unit starts the lap time from a start / finish line. If you want to start the lap time from the
moment you start moving, then you need to select 'One Shot Mode'. To set this mode:
• Press the MENU button to enter the LAP TIMING menu.
• Highlight 'ONE SHOT MODE' and press OK to activate.
• Bring the car to a halt at the start point (previously set using either set start/finish method.)
• After two seconds the following screen will appear:
• The screen will count down from 5 to 1 after it reaches 1 the following screen will appear:
• When this screen shows you can then start your lap. Timing of your lap will start as soon as you pull away and will
then stop as you cross the start / finish line at the end of your flying lap.
https://racelogic.support/01VBOX_Automotive/01VBOX_data_loggers/VBOX_Mini/
33