Input Module - Racelogic VBOX Mini User Manual

Predicitive Mode
Pressing OK when this is highlighted enables / disables predictive mode. This can also be done by pressing OK on the
main mode screen.
Comms Mode
The Comms Mode specifies the current use and configuration of the main serial port on the AUX connector.
You are able to select the current Comms Mode in the Comms Mode submenu of the Setup menu. The default mode is

input module.

COMMS MENU
INPUT MODULE
VBOX STREAM
LAPTIME TELEMETRY
LAPTIME PULSE
DRIFT TELEMETRY
YAW DIAGNOSTICS
EXIT
Input Module
Sends an input module firmware version request at 1 Hz until a response is received.
Thereafter it sends a data request on receipt of every GPS sample.
Laptime Telemetry
Sends a telemetry message when a finish or start/finish gate is crossed. If 'SplitOutput' is enabled it will send a telemetry
message when a split gate is crossed.
Laptime Pulse
Sets the lap time pulse for 0.25 seconds when a finish or start/finish gate is crossed. If 'SplitOutput' is enabled, it will set
the lap time pulse for 0.25 seconds when a split gate is crossed.
https://racelogic.support/01VBOX_Automotive/01VBOX_data_loggers/VBOX_Mini/
43