Remote Mount - Version For Flexible Vehicle Installation; Dash Mount - Version For Compact Installation - Motorola MTM800 Product Information Manual

Ordering the MTM800 & Accessories
by ordering the appropriate model, options and accessories. MTM800 is currently available in 350 -
390 MHz, 380 - 430 MHz, 410 - 470 MHz or 806 - 870 MHz. All terminals are fully TETRA compliant.
The below Remote Mount models feature a control head with full keypad and display and ships with
the options ordered. If the model is ordered with the expansion control head (found under "remote
mount accessories") an RS232 interface is available on the expansion control head.
If the model is ordered without the expansion control head (Remote Mount Kit Option), the Active
Data Cable GMKN1022 allows Short and Packet Data connectivity at the 20-pin Accessory
Connector on the rear of the terminal. You need to order GMKN1022 as a separate line accessory
item.
Additionally the transceiver MTM800 can be supplied in the following configurations:
MTM800 terminal with motorcycle control head or MTM800 TETRA as Dash / Desk Mount.
Each Model configuration has unique ordering rules and careful attention to these will ensure that
the correct options and or accessories are ordered.
6.1

Remote Mount - version for flexible vehicle installation

1. Order the main model (includes remote standard control head).
2. One option from each of the following categories is mandatory
•
•
•
Order remote mount handset/microphone option (only one selection per model)
Order remote mounting kit option (only one selection per model)
Order remote mount speaker (only one selection per model)
Order language of user guide (only one selection per model)
3. Add additional hardware accessories as needed. Note: Antenna is now a default Option for
inclusion in basic package, use Delete Option if No Antenna required
4. Customers can select from the Antenna Options shown or contact your Systems Engineer to
discuss requirements. The range of Antennas outside of these options is extensive. Note
there are two Antenna Option modes, GPS /Tetra combined or GPS with separate Tetra
Antenna.
5. Please note that the GMKN1022 is not required and should not be used with model ordered
with an expansion control head. Use the built-in 9 pin D connector instead for short and
packet data connectivity.
6. Note: Export controls apply when ordering encryption
6.2

Dash Mount - version for compact installation

1. Order the main model (includes standard control head).
2. One option from each of the following categories is mandatory
September 2008
Ordering Information
Either clear or encryption software option,
GPS option. Please note that terminals without the GPS option ordered up front cannot
be retrofitted later to have the GPS feature.
UCM option
Chapter 1 - MTM800 Product Information Manual
1-11
6866537D87-F