Motorola MTM800 Product Information Manual page 163

Tetra mobile terminals
Hide thumbs Also See for MTM800:
Table of Contents

Advertisement

Feature Flags
It is also possible to enter a known talk group GSSI via the keypad and press the PTT to set up a call
without using the search functionality above.
14.30 WAP (Wireless Application Protocol)
If enabled, allows the terminal to access the internet.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
14.31 Mail out to Group
If enabled, allows the user to send a mail to a group.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
14.32 Direct Mode (DMO) Semi-Duplex Private Call
Indicates whether the Direct Mode (DMO) Semi-duplex Private Call feature is enabled or disabled in
the phone. Also called DMO Private Call.
In this type of one-way call, the user presses and holds the PTT while talking, and releases the PTT
while listening.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
14.33 Packet Data Page Enable
Enabling this feature will allow the terminal to display the packet data page.
14.34 Multislot Packet Data
Specifies whether the Multislot Packet Data is supported or not.
When enabled on the terminal and the network, the Multislot Packet Data allows for faster Packet
Data transfer.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
14.35 DMO Repeater
Indicates whether the terminal supports the repeater feature or not.
The repeater enables to support Direct Mode communications over an enhanced coverage area as
compared to that typically achieved in direct MS-MS operation. Note that an MS will not join a call
initiated via a DMO repeater if it was received directly from the calling Direct Mode MS.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
14.36 Clear LA Blacklist on Talk Group Change
The Blacklist list stores sites that rejected the Mobile Station (MS) previously. If this feature is
enabled, the list will be cleared each time a new talkgroup is selected.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
September 2008
Chapter 3 - MTM800 Product Information Manual
3-49
6866537D87-F

Advertisement

Table of Contents
loading

Table of Contents