Motorola MTM800 Product Information Manual page 137

Tools Menu (Administrator Login)
7.1 Power Off
After upgrading the terminal's codeplug operation, select this option to power down the terminal and
take it out of the programming 'Flash Mode'.
It is also possible to restore the terminal's to its normal mode of operation by disconnecting the
terminal from the programming cable, removing and then replacing the battery.
Either way will take the terminal out of the 'Flash Mode' that is required for CPS programming.
The Power Off option is recommended when programming as the terminal will be restored to normal
operation without having to remove the battery.
7.2 Upgrade Phone
This option is used to upgrade one, or several terminals simultaneously (up to 8per computer).
It is possible to activate this operation by selecting either the "Upgrade Phone" option in the Tools
menu, or use the shortcut Ctrl+U.
CAUTION:
Do not disconnect the programming cable from the phone during the write operation. This will
destroy your terminal.
After connecting the radios CPS needs some time to detect them. Wait until all the radios are
detected and listed before clicking Continue. Otherwise the upgrading process is not performed
correctly.
When a radio cannot be detected, check if the hardware is set up properly.
After the connection is established CPS reads the radios information, lists their status and
determines whether there is an update available.
September 2008
Chapter 3 - MTM800 Product Information Manual
3-23
6866537D87-F