Canon 4K6021Z User Manual page 188

Projector Web Screen Menu
* When the interval is set to 0 seconds, repeated attempts to send mail are made
(as set in [Mail resend times]) without pausing between attempts.
Mail Authentication Settings
From [Mail auth] under [Mail] in the settings screen, you can configure the settings
for authentication of mail that is sent when an error occurs. For the setting
procedure, see "Network Setting" (P73).
Item
Mail authentication
User name
Password
Confirm password
IPv4 POP3 server IP
address
IPv4 POP3 server port
number
IPv6 POP3 server IP
address
IPv6 POP3 server port
number
POP before SMTP
response time
Sending a Test Mail
You can send a test mail to the mail address specified in [Mail] under [Mail] in the
settings screen by clicking [Send test mail] at the bottom of the screen.
Explanation
Select the mail authentication method. If
[OFF] is selected, the other mail
authentication settings cannot be
changed.
Enter the user name to use for mail
authentication in 1-byte alphanumeric
characters and symbols (1 – 63
characters).
Enter the password for mail
authentication in 1-byte alphanumeric
characters and symbols (1 – 63
characters).
For confirmation, enter the same
password as you entered in [Password].
Enter the POP3 server IP address
(IPv4) in 1-byte numbers.
Enter the POP3 server port number
(IPv4) in 1-byte numbers (1 – 65535).
Enter the POP3 server IP address
(IPv6) in 1-byte numbers.
Enter the POP3 server port number
(IPv6) in 1-byte numbers (1 – 65535).
Enter the SMTP authentication timeout
period after POP3 authentication (unit:
milliseconds) using 1-byte numbers (0 –
9999 milliseconds).
186
Factory default setting
OFF
<Blank>
<Blank>
<Blank>
0.0.0.0
110
<Blank>
110
300