Canon 4K6021Z User Manual page 150

Menu Description
Quick startup
Enable faster startup next time by leaving some circuits on for 90 minutes after the projector is
turned off. However, to avoid sudden surges in intensity, projection is delayed by at least
approximately 1.7 seconds.
Option
Off Disable quick startup.
On Enable quick startup.
Power management mode
Specify to turn the light source off or enter standby if there is no input signal. This feature
automatically turns off the light source or power after a certain period if the remote control or
projector is not operated.
Option
Disabled Disable power management mode.
Light source off Only turns the light source off.
Standby Turns the projector off and puts it in standby.
• Projection resumes when the same input signal is restored, when the remote control
or projector is operated, or when user commands are sent to turn the projector on.
• After the projector enters standby, restoring projection requires the same steps as
when turning the projector on normally.
• When [Disabled] is selected, [Direct power on] is not available.
Power management duration
Specify how much time must pass before the light source goes off or the projector enters
standby mode, depending on the [Power management mode] setting.
Option
After 30 seconds without an input signal when the projector is idle, the
5 min. – 60 min.
projector starts displaying a countdown of the selected time.
• Can be set to 5 min., 10 min., 15 min., 20 min., 30 min., or 60 min.
• If conditions that would start countdown are met while you are blanking projection,
blanking is canceled.
Direct power on
You can turn on the projector by connecting the power cable without pressing the POWER
button.
Option
Off The POWER button must be pressed to turn the projector on.
On You can turn on the projector by connecting the power cable only.
• Before enabling direct power on, be sure to set [Power management mode] to an
option other than [Disabled]. When [Disabled] is selected, [Direct power on] is not
available.
• The projector is also equipped with a Direct Power Off feature. No damage is caused
to the projector even if it is unplugged during projection to turn it off without pressing
the POWER button. However, setting adjustments made immediately before
unplugging the projector may not be stored.
Function
Function
Function
Function
148