Canon 4K6021Z User Manual page 147

Menu Description
Remote control channel
Separate channels can be assigned to up to four projectors so that a single remote control
can be used with each projector.
Selecting the Projector Channel
If a wired remote control is used, there is no need to set the remote control channel.
Option
Ch1
Ch2
Select the remote control channel to use with this projector.
Ch3
Ch4
Independent Can be controlled from a remote control set to any channel.
Selecting a Channel on the Remote Control
After changing the projector channel from the menu, always change the remote control
channel accordingly.
Ch1 Hold down both the Ch button and [1] button for 3 seconds.
Ch2 Hold down both the Ch button and [2] button for 3 seconds.
Ch3 Hold down both the Ch button and [3] button for 3 seconds.
Ch4 Hold down both the Ch button and [4] button for 3 seconds.
Independent Hold down both the Ch button and [0] button for 3 seconds.
[INPUT A-C] button settings
Select input signals to assign to INPUT A-C buttons on the remote control. This enables
direct selection of the input signals.
Option
INPUT A
Choose from the following input signals to assign: [Disable], [HDMI-1],
INPUT B
[HDMI-2], [DP-1], [DP-2], [HDBaseT] or [DP 1x2].
INPUT C
Audio in terminal select
> [System settings] >
Select the terminal for audio input used with various input signals.
Submenu
HDMI-1
HDMI-2
DP-1
DP-2
HDBaseT
DP 1x2
[Audio in terminal select]
Select the terminal for audio input.
Option
Off No audio is output.
HDMI-1 Audio signals from HDMI-1 are output.
HDMI-2 Audio signals from HDMI-2 are output.
DP-1 Audio signals from DP-1 are output.
DP-2 Audio signals from DP-2 are output.
HDBaseT Audio signals from HDBaseT are output.
145
Function
Function
Function
Function