Tf Card; Faq - Hubsan Zino 2+ User Manual

4.6.3 Tf Card

(1) support TF card, U3 above 16G/32G/64G/128G;
(2) hot plug is supported. It is recommended to plug in the TF card after switch off
the power.

5 FAQ

1.The mobile device and remote control cannot be connected
(1) Check whether the status of the APP control signal icon has changed
(2) For USB Settings on android phones, check out "Android phone connection
tutorial"
2. Aircraft cannot be searched
(1) Restart the plane, remote control and x-hubsan 2.0 APP
(2) Update the aircraft firmware
(3) Check whether the TF card slot of the drone is keeps on red light, if it flashing,
means the aircraft is abnormal
3. Picture transmission stuck or easy to lose control and disconnected
(1) Adjust the antenna Angle to the aircraft, without the block between them
(2) Change the flight site, please do not fly in tall buildings, or near signal tower
(3) Update the latest firmware
4.The aircraft is hovering unsteadily
(1) Change the flight site, please do not fly near tall buildings and signal towers
(2) Do the compass calibration and horizontal calibration of the aircraft
(3)Judge whether the wind is too strong to affect the flight
5. Aircraft GPS accuracy is not precise or cannot pass the GPS accuracy test
(1) in the open area of the outdoor with GPS over 6 satellite
(2) Walk around near the aircraft
(3) Replace the mobile device
6.The battery cannot charge
Replug the charger and battery
7. with short flight time
Battery overcharge or high temperature environment can easily lead to reduction of
battery life, it is recommended to keep the remaining 50% or so, full charge again
before use
25