Charging The Transmitter Battery - Hubsan Zino 2+ User Manual

S/N Key / Switch
Custom keys
10
Charging /
11
Adapter Port
Low Battery
12
Warning
Standby
13
Protection

2.3 Charging The Transmitter Battery

The remote is charged using the Micro USB cable as shown:
Function
Press and hold the Fn button, turn the gimbal adjustment
Wheel to adjust tthe brightness of the remote control
display at the same time.
The remote control buzzer beeps when a low battery is
triggered or RTH Press the Fn button for 1.5 seconds, and
the beep will stop. Long press the Fn button again 1.5
seconds to restore the beep.
Custom keys,set the function on the APP and save it in
when the APP is not connected, [short press] Fn doesn't
work.
Function one: Exit the current flight mode. APP is perform-
ing various functions.
In the mode, short press Fn to exit the current mode and
the aircraft hover.
Function two: short press Fn to execute gimbal return.
Function three: no function Settings)
Charge the remote control or connect with a mobile device
Low battery warning for the aircraft or remote control:
Remote control "Beep...Beep..." prompt (one time per
second)
The remote control has no operation for 10 minutes after stand-
by, the remote control "Beep...Beep..." Tips (once every three
seconds)
After 3 minutes of prompting the sound, the remote control will
automatically shut down, and there will be operation within 3
minutes, and the prompt tone will stop
The remote control charging time
is about 2.5 hours.The remote
control battery indicator light
flashes during charging.When
charging is complete, the LEDs
will be solid.
8