Aircraft Led Indications; Angle; Installing The Tf (Micro-Sd) Card - Hubsan H123D X4 JET User Manual

1.4 Aircraft LED Indicators
LED Status
Headlight (White)
Rear LEDs
(Both Red)
1.5 Adjusting The Aircraft Camera Angle
To change the aircraft's camera angle, use a
screwdriver to loosen the screws holding the camera
head in place. Manually adjust the camera head
accordingly as desired (downwards 8 degrees max,
upwards 45 degrees max) and firmly tighten the
screws afterwards.

1.6 Installing The TF (Micro-SD) Card

Locate the TF (Micro-SD) slot at the bottom of the
aircraft. Insert the Micro-SD into the aircraft to take
photos and make video recordings.
Installation:
Function And/Or Aircraft Status
During normal flight, the headlight is a solid white. Users
may also opt to turn the headlight off.
Power On All 4 LEDs flash simultaneously
W h e n t h e a i r c r a f t i s n o t c o n n e c t e d t o a
transmitter or has been disconnected from a
Flight Control
transmitter, the right rear LED will flash slowly.
Connection
Upon connection with a transmitter, the right
rear LED will become solidly lit.
Left and right rear LEDs flash alternately.
Horizontal
Calibration
All LEDs turn solid when calibration is complete.
When the user takes a photo, both rear LEDs
Photo
will flash together once.
When the user records a video, both rear LEDs
Video
will flash together slowly.
Both rear LEDs will flash together rapidly (this
Low Power indication takes priority over all others when
power is low).
TF Card Slot
08