Function Test - Viessmann Vitocom 100 LAN1 Installation And Service Instructions Manual

Registering user and setting up heating system
2. Select "Create a new system",
select system type "Vitocom 100,
type LAN1" and
enter "Connection data".
Note
The manufacturer's details can be
found on the Vitocom 100 type plate
(see page 19).

Function test

1. Simulate a fault in the heating sys-
tem, e.g. sensor fault.
Heat source service instruc-
tions
2. Check the following:
■ Operating status display "4" (see
page 19) flashes red.
■ The fault message is displayed in
the Vitotrol app and sent to the
recipients stored in the
Vitodata 100.
Note
■ If a fault is rectified, this is confirmed
with a message.
■ If the fault is not rectified, then a repeat
message is sent on the 3 days follow-
ing.
Commissioning
(cont.)
Vitodata 100 online help
25