Registering User And Setting Up Heating System - Viessmann Vitocom 100 LAN1 Installation And Service Instructions Manual

Checking the LON connection to the Vitotronic...
Updating LON subscriber list
In the following cases, the LON sub-
scriber list in the Vitocom 100 must be
updated:
■ New LON subscriber installed.
■ LON subscriber has been removed.
■ The LON communication module of an
existing subscriber has been replaced.

Registering user and setting up heating system

For operation of the heating system via
the Vitodata 100 user interface and the
Vitotrol app, a user account must be cre-
ated on the Vitodata server and the heat-
ing system must be set up. For this, carry
out one-off user registration.
Via the Vitotrol app
1. Start the Vitotrol app.
2. Press on "Create access" and com-
plete all fields on the registration
form.
Note
■ In the "Password" field, assign a
new password (min. 6 characters:
a..z, A..Z, 0..9) and confirm this in
the "Enter password again" field.
■ "Connection data" can be found
on the Vitocom 100 type plate (see
page 19).
To update the LON subscriber list, hold
down reset button "T4" (see page 19) for
approx. 10 s.
Note
If the reset button is held down for
approx. 30 s, the Vitocom 100 is returned
to its delivered condition.
3. Press "Register".
An email is sent (Subject: "Your reg-
istration for the Vitodata 100") is sent
with an activation link to the previ-
ously specified email address.
4. Open the email in your inbox and fol-
low the activation link provided to
complete the registration.
The user account and the system are
fully set up.
Commissioning
(cont.)
23