Preparing For Installation; System Requirements - Viessmann Vitocom 100 LAN1 Installation And Service Instructions Manual

System requirements

Heating system
■ The Vitocom 100, type LAN1 can be
used for one single boiler system with
Vitotronic control unit, with or without
heating circuits downstream.
■ The max. number of devices (LON
subscribers) comprising boiler and
heating circuit control units is 30.
Supported heat sources
For an up to date list of supported heat
sources, see Online help Vitodata 100
(www.vitodata100.com).
IP network
■ DSL router with a free LAN connection
(on site).
■ Internet connection with "flat rate" (flat
rate tariff independent of time and
data volume) with high level of availa-
bility, i.e. the Vitocom 100 is perma-
nently connected with the Vitodata
server.
■ Have dynamic IP addressing (DHCP)
in the network (LAN) checked on site,
and if required set up, by an IT expert
prior to commissioning.
■ Determine the routing and safety
parameters in the IP network (LAN) so
that port 80 and port 443 are approved
for direct outgoing connections. Prior
to commissioning have this checked
on site by an IT expert and, if neces-
sary, set up.

Preparing for installation

Note
During operation, the Vitocom 100
establishes a secure internet connection
to the Vitodata server. The Vitocom 100
cannot be connected to any other serv-
ers.
User account on the Vitodata server
Operating a Vitocom 100 and using the
Vitotrol app require a valid user account
on the Vitodata server. Registration is
possible either using the Vitodata 100
user interface or the Vitotrol app (see
page 23).
Operator unit for the Vitotrol app
Recommended mobile end device (for
operating system, see App Store):
■ iPhone 4 and iPhone 4S
■ iPad and iPad2
■ iPod Touch with retina display
7