Table of Contents
Advertisement
Matching the Checksum of the GERBER EDGE to the Spool
File
If the spool file you are printing
was saved in GRAPHIX
ADVANTAGE Release:
4.3 or higher
4.1
If the checksum settings of the saved spool file and the GERBER
EDGE are not the same, you will get a "Data Error" message on the
keypad display every time you send one of these files for printing. You
have two choices:
!
rerender the Release 4.1 spool files in Release 4.3 or higher so that
they are now Release 4.3 or higher files
!
set the GERBER EDGE checksum to ON when printing Release
4.1 spool files
Note: This situation only applies to spool files. Files originally created in
Release 4.1 will print as Release 4.3 or higher files if they were not saved as
spool files.
Changing the GERBER EDGE Checksum Setting
Changing the GERBER EDGE checksum setting consists of opening
the Setup menu, setting the checksum to OFF or ON, and turning the
GERBER EDGE off and on to complete the checksum change. The
checksum is toggled OFF or ON by pressing either Vinyl Slew key.
To change the GERBER EDGE checksum setting
1. Plug in and turn on the GERBER EDGE then the GRAPHIX
ADVANTAGE.
2. The GERBER EDGE display reads "OFFLINE."
Mechanical Description
Then the GERBER EDGE
checksum must be set to:
OFF (This is the GERBER
EDGE setting. You do not have
to change the setting.)
ON (You must change the
setting.)
51
Hide quick links:
Advertisement
Table of Contents
