Gerber Edge Owner's Manual page 26

To print the job
Note: There may be a pause after you press ONLINE before the printing
starts.
1. Press ONLINE on the keypad. Printing starts. After the
GERBER EDGE prints the first color, it rewinds the vinyl and the
display shows:
Foil: BLACK
To change the color cartridge
1. Raise the cover.
2. Remove the ruby red color cartridge by sliding the top and bottom
cartridge pins to the left and locking them. Slide the center cartridge
pin to the left, lock it, and remove the cartridge from the printhead
assembly.
3. Gently wipe the vinyl, vinyl squeegees, foil squeegee, and printhead
with a clean, dry, lint-free cloth.
4. Load the black color cartridge with the label on the top right of the
cartridge and the dull side of the foil facing you.
5. Rest the color cartridge on the support tabs below the printhead
assembly. Align the center notches in the sides of the color cartridge
with the center pins and seat the cartridge on the fixed pins in the
right side of the printhead assembly.
6. Release the left center cartridge pin, then release the top and bottom
cartridge pins.
7. Press the Foil Slew key to slew the foil slightly to ensure that the
color cartridge has been properly loaded.
8. Close the cover and press ONLINE on the keypad. Printing starts.
Getting Started with the GERBER EDGE 21