Gerber Edge Owner's Manual page 21

16 GERBER EDGE Owner's Guide
8. Press the Foil Slew key to slew the foil slightly to ensure that the
color cartridge has been properly loaded.
9. Close the cover.
To print the job
Note: There may be a pause after you press ONLINE before the printing
starts.
1. Press ONLINE on the keypad. Printing starts. When printing is
complete, press RESET on the keypad. The display shows:
2. Slew the material out of the back of the machine toward the roll.
Wind the job on the roll. Take the roll to the plotter.
To cut the printed job on the plotter
1. Remove the tool from the plotter tool carriage.
2. Open the bail arms by lifting them up from the drum.
3. Use the keypad slew keys to slew the plotter drive sprockets so that
the three closely-spaced teeth are facing up.
4. Seat the three-hole pattern in the vinyl over the three closely-spaced
teeth in each sprocket and close the bail arms.
5. Slew the tool carriage and vinyl so that the registration mark is
visible through the barrel of the tool carriage.
6. Press the plotter SLOW SLEW key.
Note: The plotter beeps once when you enter the Slow Slew mode and
beeps twice when you exit the Slow Slew mode.
7. Insert the eyepiece into the tool carriage as shown. Align the groove
in the eyepiece with the key in the tool carriage as shown so that the
eyepiece seats all the way down (touching the vinyl) in the carriage.
OFFLINE