Gerber Edge Owner's Manual page 54

ONLINE "ERROR" MODE
If an error occurs while printing, printing stops, an error message is
displayed in the message display area, and the GERBER EDGE enters
the Online "Error" mode. For a list of possible messages and your
response to each, refer to the "Troubleshooting" section
After taking corrective action, press the Online (ON) key to restart
printing. If the error is non-recoverable, you must press the Reset (RS)
key. The GERBER EDGE returns to the Offline mode and you must
resend the job from the GRAPHIX ADVANTAGE.
Note: If the display message is "Cooling Down," no immediate action is
required. A time delay allows the printhead to cool down. When the
printhead is sufficiently cool, the "Paused" message is displayed on the keypad.
Press the Online (ON) key to restart printing.
Before pressing the Online key to restart printing, you can:
! look at the job while it is still in the GERBER EDGE and before
printing is complete
! rehome (RH*) the cam wheel if necessary
! slew the foil (FS*).
RESETTING TO FACTORY PARAMETERS
The GERBER EDGE is set to certain parameters at the factory. If you
change these settings, or if an incorrect checksum alters the settings, the
GERBER EDGE may not operate properly. If you suspect a problem,
reset the GERBER EDGE to factory parameters and try your job again.
If you still have a problem, contact the Gerber Field Service
Department.
To reset the GERBER EDGE to factory parameters
1. Turn off the GERBER EDGE.
2. Press and hold the Reset key.
3. Turn on the GERBER EDGE and keep the Reset key pressed until
the display reads "OFFLINE."
Mechanical Description 49