Gerber Edge Owner's Manual page 39

34 GERBER EDGE Owner's Guide
6. Sight through the eyepiece and slow slew the material so that the
registration mark is exactly centered in the eyepiece as shown. You
may slow slew one step at a time by tapping the slew key, or
continuously slow slew by pressing the slew key.
View of the registration mark through the eyepiece.
7. Remove the eyepiece from the tool carriage.
8. Put the knife in the tool carriage.
9. Cut the job according to the GRAPHIX ADVANTAGE program
and plotter or console instructions.
Note: If the cut lines of the job do not match the print job, check that proper
cut registration was established at step 5. When properly centered, the knife
cuts precisely on the cross hairs of the registration mark before cutting the job.
If the cross hairs are not perfectly cut, the job will not be perfectly cut either.
Installing the eyepiece in the tool carriage.