Gerber Edge Owner's Manual page 27

22 GERBER EDGE Owner's Guide
9. When the printing of the second color is complete, press RESET on
the keypad. The display shows:
10. Slew the material out of the back of the machine toward the roll.
Wind the job on the roll. Take the roll to the plotter.
To cut the printed job on the plotter
1. Remove the tool from the plotter tool carriage.
2. Open the bail arms by lifting them up from the drum.
3. Use the keypad slew keys to slew the plotter drive sprockets so that
the three closely-spaced teeth are facing up.
4. Seat the three-hole pattern in the vinyl over the three closely-spaced
teeth in each sprocket and close the bail arms.
5. Slew the tool carriage and vinyl so that the registration mark is
visible through the barrel of the tool carriage.
6. Press the plotter SLOW SLEW key.
Note: The plotter beeps once when you enter the Slow Slew mode and
beeps twice when you exit the Slow Slew mode.
7. Insert the eyepiece into the tool carriage. Align the groove in the
eyepiece with the key in the tool carriage so that the eyepiece seats all
the way down (touching the vinyl) in the carriage.
8. Sight through the eyepiece and slow slew the material so that the
registration mark is exactly centered in the eyepiece. You may slow
slew one step at a time by tapping the slew key, or continuous slow
slew by pressing the slow slew key.
9. Remove the eyepiece from the tool carriage.
10. Put the knife in the tool carriage.
OFFLINE