Gerber Edge Owner's Manual page 25

20 GERBER EDGE Owner's Guide
To load the color cartridge
1. Press ONLINE on the keypad. The display shows:
2. If necessary, remove an installed color cartridge by sliding the top
and bottom cartridge pins to the left and locking them. Slide the
center cartridge pin to the left, lock it, and remove the cartridge from
the printhead assembly.
3. Clean the printhead with the pen printhead cleaner or use a pad
moistened with 91% isopropyl alcohol. Gently rub the entire length
and width of the printhead and the surrounding metal. Dry with a
clean, lint-free cloth.
4. Clean both sides of the foil squeegee using a pad moistened with
isopropyl alcohol. Allow to air dry.
5. Slide the three cartridge pins to the left and lock them (if not done at
step 2).
6. Remove and discard the core locks (foam donuts) from the color
cartridge. Load the ruby red color cartridge with the label on the top
right of the cartridge and the dull side of the foil facing you.
7. Rest the color cartridge on the support tabs below the printhead
assembly. Align the center notches in the sides of the color cartridge
with the center pins and seat the cartridge on the fixed pins in the
right side of the printhead assembly.
8. Release the left center cartridge pin, then release the top and bottom
cartridge pins.
9. Press the Foil Slew key to slew the foil slightly to ensure that the
color cartridge has been properly loaded.
10. Close the cover.
Foil: RUBY RED