18Wireless Remote Configuration Id; User Gpio Parameter; User Pwm Parameter - Ebyte E180-Z6907A User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd
Note: After the maximum number of rejoin attempts, if the previous network has not been restored, the previous
network information will be cleared. The power consumption of the new network scanned by Rejoin period is higher
than that of the network before the restoration. Therefore, for devices with high power consumption requirements, the
two parameters of rejoin period and Rejoin maxcount need to be set larger by default, both of which are set to 5 by
default.

6.6.18Wireless remote configuration ID

Remote Header:
remote configuration is turned on, and the default setting is 0xA88A(0xA8 0x8A).

6.6.19 User gpio parameter

Gpio: Format of peripheral configuration data（3 Byte）：GpioId In/Out level。
gpioid : Channel ID
In/Out: Channel output / input mode
0 Output
1 Input
level: Channel Level state
0 Low level
1 High level
2 Flip
Note: When configured as input, the level indicates the input level value is 0 (low level) or 1 (high level). When
the output is configured, the level indicates 0 (low level), 1 (high level), 2 (Level flip) output.

6.6.20 User pwm parameter

Pwm : Peripheral configuration data format（6 Byte）：PwmId start/stop Period1 Period2
PwmId : Channel ID
start/stop: Start/stop channel PWM output
0xFF Start PWM
0x00 Stop PWM
Copyright ©2012–2019，Chengdu Ebyte Electronic Technology Co., Ltd.
4-23
0x0000 indicates the wireless network configuration is turned off, 0x0001～0xFFFFindicates the
Channel ID
00
01
02
Channel ID
0x00
0x01
0x02
0x03
GPIO Port
PE3 Port
PA1 Port
PE1 Port
PWM GPIO Port
PB4 Port
PA0 Port
PA3 Port
PC5 Port
E180-Z6907A User Manual
duty1 duty2