Chengdu Ebyte Electronic Technology Co,;Ltd
starts to transmit data at this circumstance, it may cause overtime when the module is waiting for the user data, or
transmitting wireless sub package.
When AUX = 1, it does not mean that all the UART data of the module have been transmitted already, perhaps the
last packet of data is still in transmission.
5.6.3 Configuration procedure of module
Only happened when power-on resetting or exiting sleep mode
6. Operating Mode
The table below shows the status of corresponding modes:
Mode (0-7)
Chengdu Ebyte Electronic Technology Co,;Ltd
Copyright ©2012–2023,
M2
M1
M0
Mode introduction
E70-433TxxSx user manual
Remark
15