Multicast Test - Ebyte E180-Z6907A User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd
(3) After completing the above parameter configuration, click to enter the transmission mode, communicate in the
transmission mode.

7.3.2 Multicast test

(1) For example, if the end-device device is the receiving end, click "enter configuration mode", modify the network
group number to "5", and then write the parameters. The message box will prompt "write parameters successfully". At
this time, group ID 5 is assigned to the end-device.
(2) For example, if the coordinator is the sender, click "enter configuration mode" to enter the fixed-point
networking, select the multicast mode, and the message box will prompt "under multicast mode, all nodes with the same
group number in the network will receive multicast data", modify the target group number to "5", and then write the
parameter, and the message box will prompt "write the parameter successfully".
Copyright ©2012–2019，Chengdu Ebyte Electronic Technology Co., Ltd.
7-36
E180-Z6907A User Manual