Table of Contents
Advertisement
Chengdu Ebyte Electronic Technology Co.,Ltd.
To change the baud
of
serial
you need to restart
changed baud rate
6.6.14 Sleep time
sleep_time：（1～60）Sleep wake cycle representation 1～60 Unit (s)
（61～255）Sleep wake cycle representation 60+(61-60）*10～60+(255-60)*10 Unit(s)
6.6.15 Storage time of father nodes
Time:The maximum setting of ZigBee protocol stack is 30S, If end-device node needs to accept the parent node data, the sleep time
configuration cannot be greater than 30S.
6.6.16 Centralized network opening time
Open time ： （1～254）The time range of network opening is （1～254）*10 Unit(S)
255 Network permanent development
6.6.17 Period of network reconnection after loss of parent node
Rejoin period:
（1～255）Reconnection cycle range 1～255
6.6.18 The maximum number of attempts to reconnect
Rejoin maxcount: (0～255) The range of the maximum number of rejoins is 0～255
0: Indicates that the terminal will not perform automatic reconnection after losing its parent node
255: Indicates that the network will always be reconnected to restore the previous network, and the network clear
operation will not be performed
Note: After the maximum number of rejoin attempts, if the previous network has not been restored, the previous network
information will be cleared. The power consumption of the new network scanned by Rejoin period is higher than that of the
network before the restoration. Therefore, for devices with high power consumption requirements, the two parameters of rejoin
period and Rejoin maxcount need to be set larger by default, both of which are set to 5
6.6.19 Wireless remote configuration ID
Remote Header: 0x0000 0x0000 indicates the wireless network configuration is turned off, 0x0001 ～ 0xFFFF indicates the
remote configuration is turned on, and the default setting is 0xa88a (0xa8 0x8a).
6.6.20 User gpio parameter
Gpio: Format of peripheral configuration data (3 bytes) GpioId In/Out level
gpioid : Channel ID
Copyright ©2012–2020, Chengdu Ebyte Electronic Technology Co.,Ltd.
01
4800
02
9600
03
14400
04
19200
05
38400
06
50000
07
57600
Channel ID
00
01
08
76800
09
115200（default）
0A
128000
0B
230400
0C
256000
0D
460800
Unit(Minute)
GPIO Port
PB14 Port
PB15 Port
E180-ZG120B User Manual
rate
configuration
communication,
the device, and the
will take effect.
24
Advertisement
Table of Contents
