iFIT WEIDER PRO 8500 User Manual page 25

45. Route the High Cable (54) through the right
Upright (3) and a Swivel Arm (32). Make sure
that the High Cable is routed on the indicated
side of the small rod on the Swivel Arm.
Then, route the High Cable (54) over a 90mm
Pulley (58). Attach the 90mm Pulley inside the
Swivel Arm (32) with an M10 x 45mm Bolt (141)
and an M10 Locknut (79).
Attach a Cable Stop (52), a Clip (53), and an
M6 Locknut (100) to the High Cable (54) as
described in step 28. Make sure that at least
two threads of the High Cable show past the
Locknut.
46. Attach the Upright Backrest (29) to the Backrest
Upright (8) with two M6 x 70mm Screws (87) and
two M6 Washers (86).
45
Rod
54
52
53
79
58
100
46
29
25
32
141
3
8
87
86