iFIT WEIDER PRO 8500 User Manual page 19

28. Identify the Low Cable (72).
Slide a Cable Stop (52) onto the Low Cable (72).
Hold an M6 Locknut (100) inside a Clip (53), and
insert the Low Cable (72) into the Clip and the
Locknut. Next, hold the crimp on the Low Cable
with pliers, and insert a screwdriver between the
Clip and the Locknut. Rotate the screwdriver,
the Clip, and the Locknut together until at
least two threads of the Low Cable show past
the Locknut.
Then, slide the Cable Stop (52) onto the Clip (53).
Next, route the Low Cable (72) through the
Backrest Upright (8) and under a 115mm
Pulley (59). Attach the 115mm Pulley inside the
Backrest Upright with an M10 x 90mm Bolt (89),
two M10 Washers (84), two 25mm Spacers (55),
and an M10 Locknut (79).
29. Route the Low Cable (72) over a 90mm Pulley
(58). Attach the 90mm Pulley to the Short Double
U-bracket (46) with an M10 x 43mm Bolt (96)
and an M10 Locknut (79).
30. Route the Low Cable (72) under a 90mm Pulley
(58). Attach the 90mm Pulley to the Center Base
(2) with an M10 x 43mm Bolt (96) and an M10
Locknut (79).
28
100
52
72
53
55
84
79
29
30
58
79
2
19
8
89
84
55
59
79
46
58
96
72
72
96